Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
02-28-2016, 03:48 PM,
#1
HELP what did I DO
I bought a used hyper charger that came off another 650 classic. I followed the instructions on installing it I got it on and rejetted the carbs and needles. But when I started it up it was running fine then I saw raw gas coming out of the hyper charger on to the floor in a large amount. I think now I did the needles wrong the fourm said in 5th notch I went from the needle end up to 5th notch Should have I gone from flat end down to 5th notch. Any ideas would be great.
Reply
02-28-2016, 04:38 PM,
#2
RE: HELP what did I DO
Needle points down raising it makes it rich. Lowering, lean. 5th notch from the pointed end would lower all the way. Lean
2007 1100 custom,cobra longs and pods,doubled clutch spring.
Reply
02-28-2016, 05:37 PM, (This post was last modified: 02-28-2016, 07:33 PM by bowfish.)
#3
RE: HELP what did I DO
But what is making it run pure gas out the side. On the other sight it says to put it in the fifth notch and before I put it on ( hyper charger) it had no get up and go.
Reply
02-28-2016, 08:47 PM, (This post was last modified: 02-28-2016, 09:02 PM by nick59.)
#4
RE: HELP what did I DO
gas pouring out could be a stuck float, what notch was the needle in before, what about the pms screws did you change there settings.

http://www.650ccnd.com/rejett.htm here is info on hyperchargers and it says to count the notches from the blunt end.
2007 1100 custom,cobra longs and pods,doubled clutch spring.
Reply
02-29-2016, 12:39 AM,
#5
RE: HELP what did I DO
(02-28-2016, 08:47 PM)nick59 Wrote: gas pouring out could be a stuck float, what notch was the needle in before, what about the pms screws did you change there settings.

http://www.650ccnd.com/rejett.htm here is info on hyperchargers and it says to count the notches from the blunt end.
I tapped the float bowls on carb and the gas pouring out has stopped for now I went from pointed end up so I went the wrong way . Took bike out for a ride and no horse power at all. Will pull the needles back out again. Thanks FOR YOUR HELP
Reply
02-29-2016, 07:24 AM, (This post was last modified: 02-29-2016, 07:28 AM by nick59.)
#6
RE: HELP what did I DO
glad to be of assistance,stuck float wow

By the way that performance site. If you click on the Vstar logo in the upper left corner it will take you to a 650 forum.
2007 1100 custom,cobra longs and pods,doubled clutch spring.
Reply
Users browsing this thread:
1 Guest(s)